ATM, GTM, Tare and Payload Explained for Plant Trailers

Every plant trailer has a compliance plate covered in numbers and abbreviations, and dealers throw them around as if everyone knows what they mean. Getting them wrong can mean an overloaded trailer, a cancelled insurance claim or a fine. Here’s what each one actually means, using our own Vlemmix plant trailers as examples.

Tare

Tare is the weight of the empty trailer – nothing loaded on it and not hitched to a vehicle. Our Vlemmix plant trailers have a tare of 700 kg (3m), 770 kg (4m) and 900 kg (4m 3-axle).

Tare matters because it eats into what you can carry. Two trailers with the same ATM can have very different usable capacity if one has a heavy chassis.

ATM – Aggregate Trailer Mass

ATM is the maximum the trailer plus everything on it may weigh, measured with the trailer standing on its own (not hitched). It’s set by the manufacturer and shown on the trailer’s compliance plate. It’s a limit, not an actual weight – a trailer with a 3500 kg ATM might weigh 1500 kg on a light job and must never weigh more than 3500 kg.

All three of our Vlemmix plant trailers have a 3500 kg ATM.

Payload

Payload is how much you can legally put on the trailer, and it’s simple maths:

Payload = ATM − Tare

TrailerATMTarePayload
3m Trailer3500 kg700 kg2800 kg
4m Trailer3500 kg770 kg2730 kg
4m 3-Axle Trailer3500 kg900 kg2600 kg

Payload has to cover everything on the deck: the machine, its buckets and attachments, fuel, chains and binders.

GTM – Gross Trailer Mass

GTM is the weight carried by the trailer’s axles when it’s hitched to the vehicle. When you couple up, part of the trailer’s weight transfers onto the tow ball, so GTM is always lower than ATM. The difference between them is the tow ball load:

ATM = GTM + tow ball load

Tow ball load (tow ball mass or download)

The downward weight the loaded trailer puts on your tow vehicle’s towbar. It changes with how you load the trailer – drive the excavator further forward and it goes up; further back and it goes down. A commonly used guide is roughly 8–10% of the loaded trailer’s weight, but it must never exceed the maximum allowed by your vehicle or towbar. It also counts towards your vehicle’s GVM, which is where it starts to matter for the tow vehicle (see Can My Ute Tow a 3.5 Tonne Plant Trailer?).

Common mistakes

  • Treating ATM as what you can carry. A 3500 kg ATM trailer can’t carry a 3500 kg machine – you have to subtract the tare.
  • Forgetting the extras. Operating weight on an excavator’s spec sheet usually includes one bucket. Spare buckets, a tilt hitch, an auger and chains all add up.
  • Confusing trailer limits with vehicle limits. The trailer can be within its ATM while the ute is still over its GVM or GCM. Both have to be right.
  • Guessing. If you’re close to any limit, weigh the loaded trailer at a public weighbridge.

Why low tare is worth paying attention to

Vlemmix builds its plant trailers in the Netherlands with precision engineering and Knott axles, keeping the tare low without giving up strength. That’s why our 3m trailer can carry 2800 kg on a 3500 kg ATM. When you compare plant trailers, put the tare and payload side by side, not just the ATM.

Want help working out what you can carry? Request a quote or call us on (02) 9119 2914. Our guide to choosing the right plant trailer size for your mini excavator puts these numbers to work.